Comminuting Mill

Model	KSD-CM
*Rotor Speed	1000 - 2250 - 4500 RPM
Blades	Swinging type with knife and impact edge
* Output	25 - 300 Kgs. / Hr.
Screens	Round / Square hole perforated S.S Sheet
Woven	S.S. Wiremesh
Electric Motor	7.5 Hp /1440RPM / 440 - 380 - 220 V./ 50 -60 Hz. 3 Ph.
Net Weight(Approx)	400 Kgs.
Gross Weight(Approx)	530 Kgs.
Machine dimensions	1230 (L) x 760 (B) x 1700 (H)
Case Dimensions	1380 (L) x 1050 (B) x 1900 (H)
*Depending on the material,rotar speed & screen

G.M.P. point of view machine is provided with S. S. cladding on base, S. S. belt guards, S. S. cover on motor. No exposed painted surface on top of the machine. Motor rails, screw and guide rods are chrome plated.

Beaters assembly bearings are in a separate pillow blocks for ease in maintenance.

Very less down time as only beaters assembly will have to be reversed (and not the complete chamber) for making it knife to impact forward or vice-versa which can be done by single operator.

Fixed beaters assembly is provided as a standard supply which increase the output by 10% to 30% reduce noise level and also ease to clean as there are no cavities. (If product demands, swing beaters assembly can be provided.)

Beaters and shaft are of stainless steel 410 quality and beaters are further hardened and chrome plated. Beaters are fitted on a splined shaft

Transmission of heat to the chamber from bearings is minimum as they are away in separate pillow blocks. This facilitates to some extent in processing of heat sensitive products.

Beaters assembly is dynamically balanced which reduce vibration and noise level and increases bearings life.

Castors provided for mobility and breaks.

Machine is available in plain or water-jacketed models. Flame proof electricals can be provided on demand at extra cost.

Send Enquiry