Comminuting Mill / Cad Mill

Model	KSD-CADMILL-MINI
Output *	10 - 100 Kgs. / Hr.
Rotor Speed	1000 - 2250 - 4500 RPM
Beaters	8 Nos. Stainless steel Swinging type with knife and impact edge
Electric Motor	2 Hp / 1440 RPM / 440 -380 - 220V. /50 -60Hz. 3 Ph.
Starter	DOL
Net Weight(Approx.)	224 Kgs.
Gross Weight(Approx.)	290 Kgs.
Machine Dimensions	800 (L) x 753 (B) x 1300 (H)
Case Dimensions	1380 (L) x 1050 (B) x 1900(H)

G.M.P. point of view machine is totally enclosed with SS 304.

For safety purpose, all moving parts are covered in body by SS 304 sheet.

Very less down time as only beaters assembly will have to be reversed (and not the complete chamber) for making it knife to impact forward or vice-versa which can be done by single operator and without using any tools.

Fixed beaters assembly is provided as a standard supply which increase the output by 10% to 30% reduce noise level and also ease to clean as there are no cavities. (If product demands, swing beaters assembly can be provided).

Beaters and shaft are of stainless steel 410 quality and beaters are further hardened and chrome plated. Beaters are fitted on a splined shaft.

Transmission of heat to the chamber from bearings is minimum as they are away in separate pillow blocks. This facilitates to some extent in processing of heat sensitive products.

This facilities to some extent in processing of heat sensitive products.

Beaters assembly is dynamically balanced which reduce vibration and noise level and increases bearings life.

Castors provided for mobility & breaks can be applied for fixing machine at one place.

Machine is available in plain & water-jacketed models. Flame proof electricals can be provided on demand at extra cost.

Product kept in the hopper slides down to the enclosed chamber, where it is milled in between beaters and screen to the required mesh/micron size which can be collected at the bottom in the container.

Quality and output depends upon the three main variables.

Beaters shape. (knife/impact forward)

Speed.

Screen size.

Knife edge for coarse or large particles and impact or flat edge for finer particles. High speed for fine grinding, low speed for coarser particles. A wide range of screen is available for various process needs.

Mini Cip Mill has specifically designed for wet and dry granulation. Pulverization or dispersion of products of ingredients found in the Pharmaceutical, Chemical and Food Industries.

It also finds application in the Cosmetics, Confectionery, Fertilizers, Insecticides, Detergents and Electroflux Industries etc.

Send Enquiry